SDA500 6 1AC Raptor Case Mounted Axial Fan Single Phase AC 500mm

The Elta SDA500/6-1AC is a 500mm Raptor SDA short cased axial fan for fitting in 500mm ductwork. It moves up to 6188 m³/h in free air, 4907 m³/h at 50 Pa and still 4158 m³/h at 75 Pa, the highest pressure in Elta's published table for this model.A 6 pole single phase AC external rotor motor (220-240V 50Hz) runs at 910 rpm and draws 289 W at best efficiency (1.25 A peak). It is insulated to Class F with integral thermal overload protection and suits speed control. The Ziehl-Abegg FE2owlet aerofoil impeller has serrated trailing edges and winglets for lower noise, the mild steel case is powder coated in RAL 7045 with an IP55 terminal box, the motor is IP54, and Elta give a 12 month warranty. 1 Phase AC Motor Up to 6188 m³/h Speed Controllable What it is best used forLarger ducted duties on 500mm duct: sports halls, factory bays, warehousing, retail parks and commercial kitchens. At 50 Pa it moves 4907 m³/h, roughly 6 air changes an hour in a space of about 820 m³.Its published curve stops at 75 Pa, so it is the wrong fan for long duct runs, filters, heater batteries or attenuators; for those a centrifugal box fan or an inline mixed flow fan holds its airflow far better. It is not suitable for corrosive or explosive atmospheres, and the air must stay between -20°C and +70°C.Why choose this over alternativesThere are 5 Raptor SDA models in the 500mm case, and the choice comes down to supply, noise and control. This 6 pole single phase version runs from a standard 230V supply at 910 rpm. In the same size there is also the Elta SDA500/4-1AC (4 pole single phase, 8626 m³/h, 51 dB(A)), the Elta SDA500/46-3AC (two speed three phase, 8813 m³/h, 53 dB(A)), the Elta SDA500/4-1EC (single phase EC, 8582 m³/h, 57 dB(A)) and the Elta SDA500/4-3EC (three phase EC, 9536 m³/h, 59 dB(A)).If you need more air, the Elta SDA560/6-1AC moves 7891 m³/h in free air. For a smaller duct the Elta SDA450/6-1AC gives 4536 m³/h. If the fan will sit in a wall or panel rather than in a duct, the Elta SPA500/6-1AC plate fan uses the same Raptor impeller and motor family on a square mounting plate.Installation notes Fit it in the duct run at any angle, securely supported, with access for maintenance. The case is 250mm long with 12 holes of 10mm on a 541mm PCD at each end for Elta matching flanges 061A-0500-C, and mounting feet 060A-0500-C are available. Wire to Elta diagram 152-104B through the fitted IP55 terminal box (21mm cable entry), and connect the thermal cut-out leads (TB TB) into the control circuit so the motor is protected. For speed control Elta list the 149-EL31TK or 149-TC12 for this model; check the controller amp rating against the 1.25 A peak current. Fit a local means of isolation, and site the discharge so exhaust cannot be drawn back into a room through the open flue of a gas or fuel burning appliance. At first start check rotation, airflow direction and that the running current is within the rating plate. Inspect and clean the blades and guards at least every 12 months. You'll also need Elta 149-EL31TK 3 amp electronic speed controller (listed by Elta for this fan) Elta 149-TC12 five step transformer controller available to order, ask us Elta ancillary pack APK500SCD/002 (flexible connections, matching flanges, anti-vibration mounts and mounting feet) available to order, ask us Browse more cased axial fans, axial fans or Elta fans, or call us for help choosing the right fan.Specifications Model SDA500/6-1AC Type Cased axial fan, short case Diameter 500mm Max airflow 6188 m³/h Static pressure 75 Pa Motor Single phase AC, 220-240V 50Hz, 6 pole, 910 rpm Power 289 W (1.25 A peak) Noise 46 dB(A) at 3m IP rating IP54 motor, IP55 terminal box Warranty 1 Year Manufacturer Airflow at 50 Pa 4907 m³/h Overall efficiency 30.4% at best efficiency point FMEG 41 Case 250mm long, 503mm internal diameter, 575mm flange diameter Flange fixings 12 holes 10mm on 541mm PCD Impeller Ziehl-Abegg FE2owlet aerofoil with serrated trailing edges Finish Powder coated mild steel, RAL 7045 Operating temperature -20°C to +70°C, up to 95% RH Weight 20.5 kg Wiring diagram 152-104B Manuals & Guides Elta Raptor SDA Datasheet Elta Raptor SDA Installation Manual